Zte T-Mobile 4G HotSpot Z64 Start Manual

GETTING TO KNOW YOUR MOBILE HOTSPOT
Part
Micro-SIM
micro-SIM card slot WPS key Install the micro-SIM card.
card slot
ON/OFF switch
 Double-press to show SNTP time, SSID, Wi-Fi
password and software version on the LCD screen.
Double-press again to exit.
When the Wi-Fi function is enabled, hold it for less

WPS key than 3 seconds to disable the Wi-Fi function.
LCD screen
When the Wi-Fi function is enabled, hold it for more

than 3 seconds to active the WPS function.
When the Wi-Fi function is disabled, hold it for more

than 3 seconds to enable the Wi-Fi function only.
ON/OFF
Charging & USB port Slide it to turn on/off the HotSpot.
switch
LCD It shows the signal type, signal strength, battery, Wi-Fi,
Screen etc.
Charging/ Charge your device.

USB port  Connect the client to your device via USB cable.
Description
Reset point
Insert a pin and hold it
for 3 seconds to reset
your device.
Coverage not available in some areas. Please see coverage details
at T-Mobile.com. Device and screen images are simulated. Capable
device is required to achieve 4G speed.
INDICATORS
SET UP YOUR MOBILE HOTSPOT
Indicates that your Indicates how
Mobile HotSpot is many devices are
1. Lift SIM cover and Install SIM card.
on T-Mobile's 2G connected to the
network. Mobile HotSpot.
Indicates that your
Indicates that the
Mobile HotSpot is
Wi-Fi function is
on T-Mobile's 3G
disabled.
network.
Indicates that your
New text message
Mobile HotSpot is
in your message
on T-Mobile's 4G
Inbox.
network.
There is no battery
There is no signal.
2. Power on.
installed.
Slide to turn on
Indicates that your
Indicates that the
device is connected
battery power is low.
to the Internet.
Indicates that
your device is Indicates that the
disconnected from battery power is full.
the Internet.
Charge your Mobile HotSpot
You can charge your Mobile HotSpot using the charger included in
the box or by plugging it into your computer using the USB cable.
CONNECT & GO
Connect your Wi-Fi device to your Mobile HotSpot
1. Power on your Mobile HotSpot.
2. On your computer or other Wi-Fi enabled device, search for
available Wi-Fi Networks and select the default Network Name
(SSID) for your Mobile HotSpot.
3. Enter the default password and click OK.
Note:
It may take up to a minute to establish a connection.

Then the default Network Name (SSID) and password will

appear in the screen on your Mobile HotSpot or lift off the
battery cover to find your default Network Name (SSID) and
password