Dynojet POWER COMMANDER V Installation Instruction page 4

FIG.D
FIG.E
FIG.F
Stk connector
25-004 www.powercommander.com
PCV connector
PCV connector
6 Using the supplied velcro secure the PCV unit in place next to the fuse box
(Fig. D).
This is located under the front storage hatch. Make sure to clean both surfaces
with the alcohol swab before attaching .
7 Route the PCV harness down the left side of the vehicle and go towards the
throttle bodies.
The harness will be secured in place in a later step.
8 Unplug the stock wiring harness from the rear injector on the left side of the
throttle bodies (Fig. E).
To release the connector squeeze the spring clip into the connector.
9 Plug the YELLOW colored wires from the PCV in-line of the stock wiring
harness and rear injector (Fig. F).
09-11 CanAm Spyder PCV - 4