Dynojet POWER COMMANDER V Installation Instructions

2013 kawasaki z800

Hide thumbs Also See for POWER COMMANDER V:

2013 Kawasaki Z800

I n s t a l l a t i o n I n s t r u c t i o n s

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

I17-048

www.powercommander.com

2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

PARTS LIST

Power Commander

USB Cable

CD-ROM

Installation Guide

Power Commander Decals

Dynojet Decals

Velcro Strip

Alcohol Swab

O2 Optimizer

THE IGNITION MUST BE TURNED

OFF BEFORE INSTALLATION!

YOU CAN ALSO DOWNLOAD THE

POWER COMMANDER SOFTWARE AND

LATEST MAPS FROM OUR WEB SITE AT:

www.powercommander.com

2013 Kawasaki Z800 - PCV - 1

Need help?

Do you have a question about the POWER COMMANDER V and is the answer not in the manual?

Page 1 2013 Kawasaki Z800 Installation Guide Power Commander Decals I n s t a l l a t i o n I n s t r u c t i o n s Dynojet Decals Velcro Strip Alcohol Swab O2 Optimizer...
Page 2 Do NOT connect anything to this port unless wire into the hole of the PCV until is stops and then instructed to do so by Dynojet. It is used to tighten the screw. Make sure to reinstall the rubber transfer crank trigger data from one module to plug.
Page 3 FIG.A The installation can be done without removing the fuel tank but it may make the installation easier by doing so. Remove the main seat and the passenger seat. Mount the PCV to the inner rear fender near the battery and fuse box (Fig. A). Attach the ground wire of the PCV to the common ground wire location Ground (Fig.
Page 4 This is the 4 pin BLACK connector at the top of the row of connectors FIG.F Optimizer Plug the Dynojet O2 Optimizer in-line of the stock O2 sensor and wiring harness (Fig. F). Tuck the Optimizer behind the bracket shown in Figure. F.