Jeep Cherokee 2009 Operating Information Manual page 99

5. Electronic Throttle Control (ETC) Warning
Light — If Equipped
This light informs you of a problem
with the Electronic Throttle Control
system. If a problem is detected, the
light will turn on while the engine is
running. If the light remains lit with the
engine running your vehicle will usually be driv-
able and not need towing, however see your
authorized dealer for service as soon as possible.
If the light is flashing when the engine is running,
you may experience power loss, an elevated/
rough idle, and increased brake pedal effort, and
your vehicle may require towing. Immediate ser-
vice is required.
The light will turn on when the ignition switch is
first turned ON, and remain on briefly as a bulb
check. This is normal. If the light does not turn on
during starting, have the system checked by an
authorized dealer.
6. Malfunction Indicator Light (MIL)
This light is part of an Onboard Diagnos-
tic system called OBD II that monitors
emissions, engine, and automatic trans-
mission control systems. The light will
turn on when the key is in the ON
position before engine start. If the light does not
turn on when turning the key from LOCK or ACC to
ON, have the condition checked promptly.
96
Certain conditions such as a loose or missing gas
cap, poor fuel quality, etc. may turn on the light
after engine start. The vehicle should be serviced
if the light stays on through several of your typical
driving cycles. In most situations, the vehicle will
drive normally and it will not require towing.
If the MIL flashes when the engine is running,
serious conditions may exist that could lead to
immediate loss of power or severe catalytic con-
verter damage. The vehicle should be serviced as
soon as possible if this occurs.
CAUTION!
Prolonged driving with the MIL on could cause
damage to the engine control system. It also
could affect fuel economy and drivability.
If the MIL is flashing, severe catalytic converter
damage and power loss will soon occur. Imme-
diate service is required.
7. High Beam Indicator Light
This light shows that the headlights are
on high beam. Pull the Multifunction Con-
trol Lever on the left side of the steering
column toward you to switch to Low
beam.
8. Front Fog Light Indicator Light — If
Equipped
This light shows when the fog lights are
ON.
9. Speedometer
Shows the vehicle speed.
10. Turn Signal Indicator Light
The left or right arrow will flash in unison with
the corresponding front and rear turn signal
lights when the turn signal switch is oper-
ated.
NOTE:
• A chime will sound if the vehicle is driven
more than 1 mi (1.6 km) with either turn
signal on.
• Check for a defective outside light bulb if
either indicator flashes at a rapid rate.
11. Electronic Stability Program
(ESP)/Traction Control System (TCS)
Indicator Light
If this indicator light flashes during
acceleration, apply as little throttle as
possible. While driving, ease up on
the accelerator. Be sure to adapt your
speed and driving to the prevailing
road conditions.