General Information - Jeep Cherokee 2009 Operating Information Manual

Table of Contents

Advertisement

General Information

RKE transmitters and receivers operate on a car-
rier frequency of 433.92 MHz as required by EEC
regulations. These devices must be certified to
conform to specific regulations in each individual
country.
• This device may not cause harmful interfer-
ence.
• This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
If your RKE transmitter fails to operate from a
normal distance, check for these two conditions.
1. Weak batteries in the RKE transmitter. The
expected life of the battery is a minimum of three
years.
2. Closeness to a radio transmitter such as a
radio station tower, airport transmitter, and some
mobile or CB radios.
REMOTE STARTING SYSTEM — IF
EQUIPPED
This system uses the Remote Keyless Entry (RKE)
transmitter to start the engine conveniently from
outside the vehicle while still maintaining security.
The system has a targeted range of 328 ft (100 m).
18
Remote Start Button
NOTE:
The vehicle must be equipped with an auto-
matic transmission to be equipped with Re-
mote Start.
How To Use Remote Start
All of the following conditions must be met before
the engine will remote start:
• Shift lever in PARK.
• Doors closed.
• Hood closed.
• Liftgate closed.
• Hazard switch off.
• Brake switch inactive (brake pedal not
pressed).
• Ignition key removed from ignition switch.
• Battery at an acceptable charge level.
• RKE PANIC button not pressed.
To Enter Remote Start Mode
Press and release the REMOTE
START button on the RKE transmitter
twice. The engine will start and the
vehicle will remain in the Remote
Start mode for a 15-minute cycle.
NOTE:
• For security, power window operation and
sunroof
or
Sky
Slider
equipped) is disabled when the vehicle is in
the Remote Start mode.
• The engine can be started two consecutive
times (two 15-minute cycles) with the RKE
transmitter. However, the ignition switch
must be cycled to the ON position before
you can repeat the start sequence for a third
cycle.
To Exit Remote Start Mode without Driving
the Vehicle
Allow the engine to run for the entire 15-minute
cycle.
operation
(if

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents