Jeep Cherokee 2009 Operating Information Manual page 201

Side Repeater Light
1. Push the side repeater lens to one side to
release the spring tension and then pull it out-
ward.
2. Disconnect the bulb from the harness connec-
tor and then connect the replacement bulb.
3. Engage the right hook of the side repeater light
into the sheet metal (note correct orientation of
lettering on lens).
4. Rotate the side repeater light in place until the
left side engages (you will hear a light click).
198
Rear Tail/Stop, Turn Signal, Back-Up
and Fog Lights
1. Open the liftgate.
2. Remove the screws that fasten the taillight
housing to the vehicle.
3. Pull the taillight housing straight back to sepa-
rate it from the vehicle.
4. Disconnect the electrical connector.
5. Remove the two screws that fasten the back
plate to the taillight housing.
6. Separate the back plate from the taillight hous-
ing.
7. Pull the appropriate bulb(s) out of the back
plate and insert the replacement bulb(s).
8. Install the back plate and screws into the
taillight housing.
9. Connect the electrical connector.
10. Install the taillight housing and screws.
11. Close the liftgate.