Bosch Active Line Gen3 Owner's Manual page 123

Inserting and removing a rack battery
1
6
5
In order for the battery pack to be inserted, the key 5 must
be inserted into the lock 6 and the lock must be unlocked.
To insert the rack-type battery pack 2, slide it with the
contacts facing ahead until it engages in the holder 1 of the
rear rack/carrier.
 Always check that the battery pack is locked in
place. To do this, pull on the battery pack (after the key
has been removed).
Check if the battery pack is tightly seated. Always lock the
battery pack with lock 6; otherwise the lock can open and
the battery pack could fall out of the holder.
After locking, always remove the key 5 from the lock 6. This
prevents the key from falling out and the battery pack from
being removed by unauthorized persons when the eBike is
parked.
To remove the rack-type battery pack 2, switch it off and
unlock the lock with the key 5. Pull the battery pack out of
the holder 1.
Bosch eBike Systems
10
2
Removing a PowerTube battery
1
6
5
15
 To remove the PowerTube battery, 15 open the lock 6
using the key 5. The battery will be unlocked and fall into
the safety restraint 14.
 Press on the safety restraint from above. The
PowerTube battery will be unlocked completely and
fall into your hand. Pull the battery out of the frame.
Note: As a result of varying designs, the PowerTube bat-
tery may have to be inserted and removed using a different
method. In this case, consult the bicycle documentation
provided by your bicycle manufacturer.
121
English–10
14
2
15
0 275 U07 XPX | (8.2.18)