Replacing The Power Button With Fingerprint Reader; Procedure; Post-Requisites - Dell G3 15 Service Manual

Replacing the power button with fingerprint
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
NOTE: Applicable only for computers that are shipped with fingerprint reader.

Procedure

1 Using the alignment posts, align the power button on the palm rest and keyboard assembly.
2 Slide and place the power button into the slots on the palm rest and keyboard assembly.
3 Replace the screw (M2x2) that secures the power button to the palm rest and keyboard assembly.
4 Adhere the fingerprint reader cable on the palm rest and keyboard assembly.

Post-requisites

1 Replace the display assembly.
2 Replace the system board.
3 Replace the power-button
4 Replace the wireless card.
5 Replace the heat sink.
6 Replace the fan.
68

Replacing the power button with fingerprint reader

computer. After working inside your computer, follow the instructions in
board.
38
reader
After working inside
www.dell.com/