LoadLifter 5000 Series
Reinstalling the Fender Well Liner
— Late Model 4WD DODGE ONLY
1. If this installation was on a late-model 4WD Dodge truck, it is now necessary to
2. Place the spacer between the fender well liner and the fender well at the center hole
Fasten the 1/4" hex-head cap screw with the washer and nut behind the fender well
NOTE
(fig. 22). Tighten securely.
3. Replace the remaining fender well liner rivets carefully. Push the rivets through the
4. From the opposite side, use a rubber mallet and carefully tap the rivet posts back
MN-1046
reinstall the inner fender well liner using the original fasteners and provided spacers
to allow for air spring clearance (fig. 20).
in the fender well liner (the hole nearest the air spring). Attach using the 1/4" hex-
head cap screw, the 10/32" flat washers, and 1/4" nylon lock nut provided (fig. 21).
1/4" Hex-head
cap screw
10/32" Flat washer
Fender well liner spacer
fender well liner by hand. They should push through completely (fig. 22).
into the rivets in order to secure them properly (fig. 23). Repeat this process for all
remaining rivets.
Rivet locations
Before
After
Fender well liner
10/32" Flat washer
fig. 22
fig. 20
Fender well
fig. 21
1/4" Nylon lock nut
Fender well
fig. 23
13