-40-
DISKETTE UNIT - Removals/Replacements
BAIL SOLENOID AND IDLER REMOVAL
CAUTION
When a diskette drive is removed from its mounting, the
ground through the AC connector must be verified. Verify
the ground by checking for 0 ohms between the Diskette
Unit base and the diskette drive.
1.
Turn the system power off.
2.
Disconnect the bail actuator cable from the bail cable
stud.
3.
Remove the solenoid cable connector from the file
control card.
4.
A.emove the AC motor drive belt.
0
5.
Remove the solenoid, bracket and cable as a unit.O
6.
Remove the idler.
0
7.
Loosen the solenoid locking setscrew and unscrew the
solenoid from the bracket.
0