Mdi Prompt Responses - IBM 6580 Product Support Manual

-96-
DIAGNOSTICS - MOl Prompt Responses
MDI PROMPT RESPONSES
The following is a description of the responses which can be
used during MDI.
a
=
Option:
t
=
Trace:
y
=
Yes:
n
=
No:
Return to the MDI options menu to enter
new options. From the options menu, press
the ENTER key to return to the last step.
Display a trace of the steps performed and
the decisions made in each step. Decisions
may be:
YES
(y)
NO
(n)
GO TO STEP (g)
GO TO MAP (m)
FIX
(f)
When a "GO TO MAP" step occurs,
the trace table will contain the MDI
number as the entry following the
"GO TO MAP" step.
While displaying the trace table, pressing
ENTER will return to the last step.
The answer to this question is yes. Con-
tinue on the yes column of the MDI.
The answer to this question is no. Continue
on the no column of the MD I.
b
=
BACK UP: Return to the last step which was per-
formed. This response is not valid if
entered at the start of a subsection. When
it is necessary to back up more than one or
two steps, return to the options menu and
enter a "start on" step number.
r
=
RESUME: Return to the same step in. the MDls after
the system is turned off. There are two
modes of resume, automatic and manual.
Automatic resume occurs when the M D I
step instructs you to turn the system off
to perform a service check. When the CE
Diagnostic Diskette is reloaded and MDls
are selected, the system will instruct to
press ENTE R to resume M D I processing.
To resume on an MDI step that is not
automatic. it is necessary to type an fir"
and press ENTER before turning the sys-
tem off.
C. E_ Diagnostics
CED201
Good Test Unit' results?
MDls Keyboard
CANCEL to return to Device Selection:
END to return to Function Selection.
Type y,n,(b,o,t,r), press ENTER: y
t·1emory xxxx
Kyb 001
MAP Description:
This MAP isolates Keyboard problems_
Overrun test for the keyboard.
Test - YES NO
Received - YES
Section
Subsection
Step
. Mode
- 10
- 70
- 001
- Step
Test Unit Prompt Responses Display