Table of Contents
Advertisement
ENGLISH
Basic Recording
Setting the Zero Memory (VP-D353(i)/D354(i)/D355(i) only)
✤
The ZERO MEMORY function works in both Camera and Player modes.
✤
You can mark a point on a tape that you want to return to following playback.
1. Set the Power switch to CAMERA or PLAYER.
2. Set the Mode switch to TAPE.
3. Press the ZERO MEMORY button on the remote control
before the recording or during playback at the point where you
wish to return.
The time code is changed to a tape counter that is set to
I
ZERO MEMORY with the
indicator).
If you want to cancel the ZERO MEMORY function, press
I
the ZERO MEMORY button again.
4. Finding the zero position.
When you have finished playback, fast forward or rewind
I
the tape in stop mode.
The tape stops automatically when it reaches the zero
position.
When you have finished recording, set the Power switch to
I
PLAYER and press the
The tape stops automatically when it reaches the zero position.
5. The tape counter with the
display and the tape counter is changed to the time code.
[ Notes ]
I
In the following situations, ZERO MEMORY mode may be canceled
automatically:
- At the end of the section marked with the ZERO MEMORY function.
- When the tape is ejected.
- When you remove the Battery pack or power supply.
I
The ZERO MEMORY may not function correctly where there is a break
between recordings on the tape.
42
42
1
0:00:00 (ZERO MEMORY
(REW) button.
(ZERO MEMORY indicator) disappears from the
✤
✤
I
I
I
œ
I
I
I
Hide quick links:
Advertisement
Table of Contents
