Table of Contents
Advertisement
4. Setting (continued)
4. Turn off the power supply of driver.
The initial setup is now completed.
Next, establish the wireless system between the terminal
and driver by using the product.
1. Turn on the power supply of access point.
2. Connect the product to the connector X1 of the driver.
3. Turn on the power supply of driver and check that the
lamp of the product lights up.
4. Change the network setting of the terminal you want to
use and connect to the target access point.
5. Use the terminal to start up the setup support software.
6. When the communication with the product has been suc-
ceeded, the nickname, part number and serial number of
the corresponding driver will be displayed on the driver
select screen.
7. When the driver is selected which is the target to connect,
the entry of PIN code will be requested, and so enter the
PIN code you set at the initial setup.
8. When the correct PIN code is input, the main screen of
the setup support software will open.
Afterward, parameter setting or status monitoring can be
carried out by wireless communications by using the setup
support software.
For the method to use the setup support software, sepa-
rately refer to the operating manual of each setup support
software.
－ E22 －
5. General Specifications
Power
DC 5V (Supplied from USB) 500 mA
supply
Power
Max.2500 mW
consumption
Outline
dimensions
Appr. 4 g
Weight
Temperature for use:
Ambient
0 °C – 55 °C (Shall be no freeze)
temperature
Temperature for storage:
for use
–20 °C – 65 °C (Shall be no condensation)
Ambient
20 % – 85 % RH both for use and storage
humidity for
(Shall be no condensation)
use
USB mini-B
Interface
Conformable to IEEE802. 11b/IEEE802.
Standards
11g/IEEE802. 11n
－ E23 －
39.4
31.9
Unit: mm
Advertisement
Table of Contents
