Setting The Zero Memory - Samsung SC-D6550 Owner's Instruction Book

ENGLISH ENGLISH
The Camcorder : Basic Recording

Setting the Zero Memory

✤
The Zero Memory function works in both REC and PLAY modes.
✤
You can mark a point on a tape that you want to return to following playback.
1. Set the Power switch to REC or PLAY.
2. Press the ZERO MEMORY button on the remote control before the recording or during
playback at the point where you wish to return.
I The time code is changed to a tape counter that is set to Zero Memory with the
0:00:00 (Zero Memory indicator).
I If you want to cancel the Zero Memory function, press the ZERO MEMORY button again.
3. Finding the zero position.
I When you have finished playback, fast forward or rewind the tape in stop mode.
The tape stops automatically when it reaches the zero position.
I When you have finished recording, set the Power switch to PLAY and press
the (REW) button.
The tape stops automatically when it reaches the zero position.
4. The tape counter with the
tape counter is changed to the time code.
[ Notes ]
I In the following situations,
- At the end of the section marked with the
- When the tape is ejected.
- When you remove the Battery pack or power supply.
Zero Memory
I The may not function correctly where there is a break between recordings on the
tape.
44 44
(Zero Memory indicator) disappears from the display and the
Zero Memory
mode may be canceled automatically:
Zero Memory
function.
1
2
œ