Table of Contents
Advertisement
ALLPLEX track Personnel Transmitter
6
Basic Transmitter Features
This section provides information of the various features of the transmitter.
6.1
Transmitting a Manual Alarm
Initiate an alarm by pressing and holding the Alarm button for 1 second. This emits a series of
mixed tones for 2 seconds and sends an alarm signal to the Central Console. If alarm is
activated within sight of a receiver, the red LED on the receiver lights up. After initiating a
manual alarm, the Auto Tracking feature sends your latest location to the Central Console
every 7 seconds (configurable).
Reset the transmitter after a manual alarm by performing a test as described in Testing the
Transmitter, page 16.
6.2
Man-Down Alarm
Whenever you are in a prone position (60° from upright) for more than 5 seconds
(configurable), the transmitter emits a series of mixed tones for 2 seconds, and sends an
alarm signal to the Central Console. There are no tones or alarm signal if transmitter is
restored within 5 seconds (configurable). If alarm is activated within sight of a receiver, the
red LED lights up.
Reset the transmitter after a Man-Down Alarm by returning the transmitter to the upright
position and performing a test as described in Testing the Transmitter, page 16.
6.3
Lanyard Snatch Alarm
Initiate an alarm by pulling the lanyard off the transmitter. This emits a series of mixed tones
for 2 seconds, followed by short beeps at 250 millisecond intervals. The transmitter sends an
alarm signal to the Central Console. If activated within sight of a receiver, the red LED of the
receiver lights up. The Auto Tracking feature sends the latest location to the Central Console
every 7 seconds (configurable).
To reset the transmitter after a Lanyard Snatch Alarm, reinsert the lanyard pin and perform a
test as described in Testing the Transmitter, page 16.
Robert Bosch (SEA) Pte Ltd
Installation Manual
Basic Transmitter Features | en
2014.03 | V1.0.0 | DL
13
Advertisement
Table of Contents
