Table of Contents
Advertisement
Pendant transmitter, 433MHz
3
Installing the transmitter
This section provides information on how to install the battery and set up the transmitter.
The transmitter uses a 3 VDC, CR2032 lithium coin cell battery. The following battery types
are recommended: Duracell® DL2032, Eveready® CR2032, or Panasonic® CR2032.
Assuming normal usage (such as weekly testing), the battery life of SEC-RFPB60M-433 should
be approximately 3 years.
Notice!
This equipment can be damaged by static electricity. Use a ground strap or grounded
workstation when changing batteries.
You need a Phillips P1 screwdriver to install or replace the batteries.
1.
2.
Bosch Security Systems B.V.
Use the screwdriver to remove the screw from the back cover of the transmitter.
Remove the back cover from the transmitter.
Installation Manual
Installing the transmitter | en
2019.07 | SE3v1.1 | DL
9
Advertisement
Table of Contents
