ABB REF 541 Product Manual page 35

Feeder Terminal
Settings of power quality functions
Current waveform distortion measurement, PQCU3H, PQ 3inf (PQ 3inf)
The current waveform distortion measurement PQCU3H is used for measurement and statistical analysis
of current waveform distortion. The standards concerning voltage distortion measurement are applied to
current distortion measurement in PQCU3H. Data collection and analysis is done according to EN 50160.
Measuring principles for individual harmonics and THD are adapted from the International standard IEC
61000-4-7. The American standard IEEE Std 1159 is also partly supported. Analysis can be done for one
selected phase current or most distorted phase current can be tracked.
Measuring modes
Measurement activation
Triggering mode
Distortion factor
Monitored values
THD (3 sec and 10 min mean values)
Harmonic components from 1st to
13th (3 sec mean values)
Harmonic components from 2nd to
13th (10 min mean values)
Statistics
Observation times for statistics
Percentile setting
Percentiles for each harmonic and
THD
Five fixed percentiles (1,5,50,95,99)
for one selectable harmonic or THD
Maximum values for each harmonic
and THD
Recorded data
Harmonic limit supervision
Limit for THD
Limits for each harmonic
Recorded data
Operation criteria
Fundamental frequency
Frequency deviation
Amplitude of the fundamental wave
Measurement accuracy
Measured harmonic Im = 1st, ... ,
10th
Measured harmonic Im = 11th, ... ,
13th
Voltage waveform distortion measurement, PQVO3H, PQ 3unf (PQ 3unf)
The voltage waveform distortion measurement PQVO3H is used for measurement and statistical analysis
of voltage waveform distortion. Data collection and analysis is done according to EN 50160. Measuring
principles for individual harmonics and THD are adapted from the International standard IEC 61000-4-7.
The American standard IEEE Std 1159 is also partly supported. Analysis can be done for one selected
phase or phase-to-phase voltage or most distorted phase or phase-to-phase voltage can be tracked.
Measuring modes
Measurement activation
Triggering mode
REF 541, REF 543, REF 545.
Not in use; L1; L2; L3; Worst phase
Triggering by: setting parameter, binary input, date & time setting
Single; Continuous; Periodic
THD; TDD
0.0 ... 1000.0%
0.0 ... 1000.0% In
0.0 ... 1000.0% In
1 hour; 12 hours; 1 day; 2 days; 3 days; 4 days; 5 days; 6 days; 1
week
90.0 ... 99.5%
0.0 ... 1000.0% In
0.0 ... 1000.0% In
0.0 ... 1000.0% In
One data set for updating; One data set from the previous
observation period
0.0 ... 60.0%
0.0 ... 40.0% In
If any limit should be exceeded, the whole harmonic set will be
recorded during the maximum THD (3 sec values)
0.9 ... 1.1 Fn
 0.5 Hz (difference between max and min values within one
second)
 1% In
In accordance with IEC 61000-4-7
 1.0% In, if Im < 10% In;  10% Im, if Im  10% In
Not in use; L1; L2; L3; Worst phase; L1-L2; L2-L3; L3-L1; Worst
main
Triggering by: setting parameter, binary input, date & time setting
Single; Continuous; Periodic
1MRS750443-MBG
35