Setting The Maximum Information Rate; Displaying The Inventory - Radwin 1000 User Manual

Setting the Maximum Information Rate

4. Click Apply to save the changes.
It is possible to close the Ethernet service by disconnecting the Ethernet
port.
Note
If you close the port, you may subsequently be unable to access the
device. If this should occur, a workaround is as follows:
•
•
•
Setting the Maximum Information Rate
The maximum Ethernet throughput of the link can be limited. The default
setting is Not Limited (see
tion rate available for the link conditions and settings is used.

To limit the Ethernet information rate:
1. From the Configuration menu, choose the site to reconfigure.
2. Click Advanced | Ethernet
The Configuration dialog box opens.
3. In the Information Rate pane, use the drop-down menu to choose the
maximum Information Rate.
4. Choose Other to define the throughput with 1 Kbps resolution
5. Choose Not Limited for the highest information rate possible for the
link conditions and settings
6. Click Apply to save the changes.

Displaying the Inventory


To view the inventory data
1. Choose a site from the main menu.
The Configuration dialog box opens.
2. Choose Inventory
RADWIN 1000/2000/5000 User ManualVersion 2.5.30p3
Connect the system from the remote site
Connect via other Ethernet port (of the IDU)
Power down the equipment and connect immediately after power
up (the fastest way is to enter install mode)
figure 6-9
(figure 6-10).
above), where the highest informa-
Chapter 6
6-12