Table of Contents
Advertisement
6. Software Control - Lightware Device Controller
6.7.5. User Preferences
The tab shows some settings in connection with the LDC displaying/
working mode.
These settings are saved by the LDC and applied next time when the
software is started (independently from the type of the matrix). The
size of the LDC window is also restored from the last run.
6.8. Terminal Window
This general purpose terminal is intended mainly for testing and
debugging purposes. When a successful connection is established
with a router this terminal can be used either via serial RS-232, TCP/IP
LAN or USB connection. All commands can be used here that are
discussed in the programmer's reference. The command text can be
typed directly.
By default commands are automatically surrounded by framing
brackets. Every sent command and every received response gets an
arrow (-> or <-) prefix, and has different font colors in order to help to
distinguish.
The timecode in every row shows the exact time when the command
was sent or the response received.
If the Command framing checkbox is unchecked, you can send multiple
commands together, however in this case you have to type in the
framing brackets manually.
The terminal can be also opened after starting the LDC - press the
Terminal button on the Device discovery page on the bottom of the
window.
TIPS AND TRICKS: The typed commands can be 'browsed' when
the cursor is in the command line and you press the up button on
the keyboard. The commands are stored until the LDC is closed.
MX8x8HDMI-Pro series – User's Manual
The User Preferences Tab
The Terminal Window
32
Advertisement
Table of Contents
