Table of Contents
Advertisement
7. Programmers' Reference
7.4. Network Configuration
7.4.1. Query the Current IP Configuration
Description: IP address settings can be queried as follows.
Format
Command {IP_CONFIG=?}
Response (IP_CONFIG=<type>•
<ip_address>•<ip_port>•
<subnet_mask>•
<gateway_addr>)CrLf
Legend:
<type>:
<ip_addr>:
<ip_port>
<subnet_mask>:
<gateway_addr>:
Explanation: The device has DHCP IP address: 192.168.0.103; the port number is 10001; the subnet mask is
255.255.255.0, the gateway address is 192.168.0.1.
For the default TCP/IP parameters see the
7.4.2. Reload Factory Default IP Settings
Description: After issuing this command (either over serial or IP) the router will reload the factory default IP
setup.
Format
Command {IP_CONFIG=!}
Response (Changing IP configuration...)
(DONE!)CrLf or (FAILED!)CrLf
For the default TCP/IP parameters see the section.
7.4.3. Enable DHCP IP Setting
Description: After sending this command the router will inquire IP address with DHCP.
Format
Command {IP_CONFIG=D}
Response (Changing IP configuration...)
(DONE!)CrLf or (FAILED!)CrLf
INFO: DHCP setting can be reloaded by the front panel buttons as well (see the
the front panel LCD menu.
Example
{ip_config=?}
(IP_CONFIG=7 192.168.0.103 10001
255.255.255.0 192.168.0.1)
0 = static IP; 7 = DHCP.
IP address.
IP port
Subnet mask
Gateway address
Factory Default Settings
section.
Example
{IP_CONFIG=!}
(Changing IP configuration...)
(DONE!) or (FAILED!)CrLf
Example
{IP_CONFIG=D}
(Changing IP configuration...)
(DONE!) or (FAILED!)CrLf
IP Settings
MX8x8HDMI-Pro series – User's Manual
7.5. EDID Router Commands
7.5.1. Change EDID on Input
Description: Copy EDID from memory location <loc> to input port <in>.
Command
Response
Explanation: EDID #10 is copied to input 5.
INFO: The router sends (E_S_C) only if the new EDID is different from the earlier one.
7.5.2. Change EDID on All Inputs
Description: Copy EDID from memory location <loc> to all inputs.
Command
Response
Explanation: EDID #2 is copied to all inputs.
7.5.3. Save EDID to User Memory
Description: Learn EDID from the specified output <out> to the specified location <loc>.
Command
Response
Explanation: EDID from output 3 is saved to user EDID #4.
section) or via
Format
{<in>:<loc>}
{5:10}
(E_SW_OK)CrLf
(E_SW_OK)
...delay...
...delay...
(E_S_C)CrLf
(E_S_C)
Format
{A:<loc>}
{a:2}
(E_SW_OK)CrLf
(E_SW_OK)
...delay...
...delay...
(E_S_C)CrLf
(E_S_C)
Format
{<out>><loc>}
{4>3}
(E_SW_OK)CrLf
(E_SW_OK)
(E_S_C)CrLf
(E_S_C)
38
Example
Example
Example
Advertisement
Table of Contents
