Table of Contents
Advertisement
8. Firmware Upgrade
Step 4: Find the Device and Establish the Connection
Make sure that no other active connection is established to the matrix (running the Lightware Device
Controller software or a web browser and the built-in website). Please wait until all the devices on the
network completely start up, then click on the Find button to query the Ethernet; the discovered devices are
listed.
Lightware Bootloader – Searching for Devices
If the desired device is not discovered for some reason
but you know its IP address you can add it manually.
Press the Add IP button and fill the text boxes. Double
click on the IP address, then click Yes to establish the
connection. It will take 10-15 seconds to load all the
information.
MX8x8HDMI-Pro series – User's Manual
ATTENTION! The bootloader application will restart the matrix when it establishes the connection. All
connected DVI sources and monitors will act as if the matrix was powered down. The matrix beeps when
it is rebooted.
Step 5: Select the Desired Controllers
After the connection is made, the device properties and the installed controller modules are displayed.
Lightware Bootloader – Details of the Device
50
Advertisement
Table of Contents
