Battery Pack, Capacity, And Signal Display; Preparing For Work With The Power Tool - AcraDyne ABG Series Operation And Service Manual

4.1.2 Battery Pack, Capacity, and Signal Display*

Push button (8) on the battery pack and check the
charge status. If the battery pack is almost empty, it
must be recharged. Replace the battery pack on the
power tool.
If one of the LEDs flashes, the battery pack is almost
empty. The electronic circuitry protects the battery
pack against damage due to complete discharge.
Replace battery back on the power tool. Recharge
battery pack.
* Charge status indicators are approximate and may be slightly
different, depending on the battery pack type.
ABG Battery-Powered Nutrunners
4.2

Preparing for Work with the Power Tool

Before preparing the power tool for work remove
the Li-Ion battery pack from the tool.
Depending on the specific job, various adapters for tightening
and loosening of bolted connections are needed.
• Place the ABG Nutrunner on a flat surface.
• If the reaction torque absorber is fitted with a safety
screw, completely remove this screw (the position of this
screw varies between the tool types).
• Push the reaction bar (9) onto the gear cogs (10).
• Tighten the safety screw completely to secure the
reaction bar.
For reaction bars without safety lock, a safety washer is
available as an accessory. This washer prevents a loosening
of the reaction bar and can be pushed over the gear cogs and
screwed tight.
• Push the socket/connector (11)/(12) onto the square
drive (bore holes of the adapter and of the square must
be aligned).
• Insert safety pin (13), secure with rubber ring (14) or
completely tighten connector safety screw (15).
•
6