Recording A Sequence - Mutable Instruments Edges User Manual

Hold one of the 4 WAVEFORM SELECT
Press 1 to enable/disable semitone quantization on this channel. Led 1 indicates whether the quantizer is
enabled.
Press 2 to enable/disable the sequencer. Led 2 indicates whether the sequencer is enabled. Hold any one
of the 4 WAVEFORM SELECT
Hold one of the 4 WAVEFORM SELECT
sequence. Leds 3 and 4 will blink.
Press 3 to start recording. Led 1 lights on to indicate the active step (step 1). Set the
selected channel to the desired note; or enter a note from your CV keyboard or through your MIDI-CV
interface. Press the second switch to continue to the next step. Set the
channel to the desired note for the second step. Press the third switch to continue, etc. To stop recording,
press the currently active step. For example, to record a 6 step sequence:
1. Press 3 to start recording. The sequencer starts at step 1.
2. Set CV
3. Press 2
4. Set CV
5. Press 3
6. Set CV
7. Press 4
8. Set CV
Mutable Instruments | Edges
switches to modify this channel's options. Leds 3 and 4 will blink.
switches to exit the settings mode.
switches to select the channel in which you want to record a
3 of 5
FREQ control on the
FREQ control on the selected