Getting Started; Alarm Modes - Tunstall The Vibby User And Installation Manual

Getting started

The Vibby is shipped in Storage Mode, it is important to exit
Storage Mode by following the instructions below.
1)
2)
3)
After exiting Storage Mode, the Vibby will automatically enter
Demo Mode for 5 minutes flashing with a green LED every 5
seconds. Put your Vibby down in a safe place for the 5 minutes
until the green LED stops flashing when it will then enter Active
Mode ready for use.
2
Press and hold the button.
Release the button when the
red LED starts flashing.
The Vibby will vibrate and the
LED will be off. You have now
exited Storage Mode.

Alarm modes

Once in Active Mode, please put your Vibby on as it is ready to
use. The Vibby can raise alarms in two ways; manual calls - when
the user presses the help button, and automatic calls - which are
generated if the Vibby detects a heavy fall.
To raise a manual alarm call; press
the Vibby's help button for one
second.
An automatic alarm is sent when a
heavy fall is detected.
IMPORTANT NOTE
Considering the technology used and the target to minimise
false alarms, some falls, even heavy/dangerous falls, cannot be
detected. For this reason, whenever the user needs assistance
they should always press the help button on the Vibby.
3