Nikon KeyMission 360 User Manual page 29

4
Press and hold down the movie button
(about 7 seconds) on the camera.
Press and hold down the movie button until the
status lamps flash green at the same time, even if
you hear the startup sound.
The status lamps flash green at the
same time for a while and then
alternately flash green (the camera is
in pairing standby mode).
5
Tap the camera name when it is displayed on
the screen.
For iOS:
When you tap the camera
name, a dialog explaining the
procedure is displayed.
Confirm the details and tap
Understood.
When the accessory selection
screen is displayed, wait for the
Bluetooth icon at the top right
corner of the screen to change
from white to gray, and then
tap the camera name again. It
may take a while before the
camera name is displayed.
If pairing is successful, the
screen shown on the right is displayed.
If pairing fails, the status lamps flash red six times at the
same time. When a message indicating that pairing has
failed is displayed on the screen, tap OK and repeat the
pairing procedure by following "When You Cannot Pair
with a Smart Device" (A18).
Pairing with the Camera
• Following the on-screen instructions, select
the camera name.
Understood
Using SnapBridge 360/170
Pairing with the Camera
Select the camera name from the list.
The camera consists of the model name
followed by an underscore and the serial
number. The serial number is printed on a label
on the camera.
Choose a camera for pairing
KeyMission 360_XXXXXXXX
Pairing with the Camera
Select An Accessory
KeyMission 360_XXXXXXXX
Cancel
Understood
Connect
KeyMission 360
15