Bissell POWERFORCE HELIX 2110 SERIES User Manual page 9

Maintenance:
1
Maintenance:
1
Unplug vacuum, turn over and
unscrew Philips head screws
to remove bottom cover.
Model 2111 has 5 screws and
model 2110 has 6 screws.
Maintenance:
1
Remove the hose
from the back of the
vacuum by twisting
it to the left. Remove
any debris that may
have gotten clogged.
Cleaning the Separator
2
Remove the
separator by
Press the
twisting to the
tank release left then pull it
button.
out through the
Pull handle
bottom of the
to lift dirt tank. Rinse and
container
dry all sections
away from
of dirt
vacuum. container with
paper towel.
Replace the Brush & Belt
2
Lift roller straight
out. If the belt is not
broken, remove roller
from inside of the
looped belt.
Clearing a Clog
2
air path
Check the foot hose on
the back of your vacuum
down towards the bottom.
If necessary, remove the
screw from the foot hose
and check for clogs.
Model 2111
3
Replace the brush roll and
belt by looping the belt over
the motor shaft and the brush
roll. Line up the end caps
and pull the brush forward
into place. This will stretch
the belt. Once the brush roll
is installed, place the bottom
cover back on and replace
the screws.
screw
3
Check the air passageway on
the bottom of your vacuum.
Remove the bottom cover and
the brush. Remove any debris.
Model 2110
www.BISSELL.com
9