Hitachi RASC-4HNPE Service Manual page 32

2 Unit installation
Interchangeability of air inlet and outlet panels
8 Once the fan is placed to the optional position,
proceed to the assembly of the fan duct
accessory (provided separately).
- HITACHI accessory code:
Š 7E590904 (for 4-6 HP)
Š 7E590905 (for 8/10 HP)
9 The fan duct accessory consists of 4 plates:
2 long plates (for horizontal position) and 2
short plates (for vertical position).
They must be assembled as follows:
i. There is 1 long and 1 short plate with
a notch. Ensure that they match for a
correct assembly.
ii. Once those plates match, proceed to
tighten the 4 screws (1 for each edge).
The screws must have been kept
from the disassembly of the fan duct
assembly.
iii. After the accessory is mounted,
proceed to place it to the fan unit. The
notch must be at the top-left side of the
fan unit. 8 screws are required to fix
the duct accessory, which must have
also been kept from the disassembly of
the fan duct assembly.
?
N O T E
Carefully read the instructions provided
with the fan duct accessory for a proper
assembly.
10 Exchange the position of the air outlet panel
and fan service cover.
22 SMGB0091 rev.2 - 11/2015
NOTCH
Fan service
cover
Air outlet panel