Windshield Washer Fluid; Air Cleaner - Suzuki Jimny Owner's Manual

Engine Coolant: 1, 2
INSPECTION AND MAINTENANCE
3) Loosen the drain plug attached to the
lower part of the radiator and drain the
coolant into a suitable container.
4) Reinstall the reservoir and fill it with
coolant to the "FULL" line.
5) Tighten the drain plug on the radiator.
6) Fill the radiator with coolant and install
the radiator cap.
7) After filling, let the engine idle for about
2–3 minutes to get rid of air in the cool-
ing system.
8) Stop the engine.
9) Check the coolant level in the radiator
again. If the level has gone down, add
more coolant.
NOTICE
The coolant must be replaced with
the vehicle on level ground.
8-17

Windshield Washer Fluid

Front and rear
EXAMPLE
54G102
Check that there is washer fluid in the tank.
Refill it if necessary. Use a good quality
windshield washer fluid, diluted with water
as necessary.
WARNING
Do not use "antifreeze" solution in
the windshield washer reservoir. This
can severely impair visibility when
sprayed on the windshield, and can
also damage your vehicle's paint.
NOTICE
Damage may result if the washer
motor is operated with no fluid in the
washer tank.

Air Cleaner

EXAMPLE
54G103
If the air cleaner is clogged with dust, there
will be greater intake resistance, resulting
in decreased power output and increased
fuel consumption.
Check and clean periodically according to
the following procedure:
1) Take off the air cleaner case cover.
Remove the element from the air
cleaner case cover.
2) This air cleaner element is of dry type.
Remember that it needs cleaning
according to the following method.
3) Blow off dust on cleaner element by
compressed air from inside the ele-
ment, or replace the element as neces-
sary.
81A091
81A2G-01E