Towing: 6 - Suzuki Jimny Owner's Manual

Jump Starting Instructions: 9, 10

Towing: 6

EMERGENCY SERVICE
When Jump Starting Your Vehicle,
Use the Following Procedure:
1) Use only a 12-volt battery to jump start
your vehicle. Position the good 12-volt
battery close to your vehicle so that the
jump leads will reach both batteries.
When using a battery installed on
another vehicle, DO NOT LET THE
VEHICLES TOUCH. Set the parking
brakes fully on both vehicles.
2) Turn off all vehicle accessories, except
those necessary for safety reasons (for
example, headlights or hazard lights).
9-3
1
4
3
(3)
EXAMPLE
3) Make jump lead connections as follows:
60A269
1. Connect one end of the first jump
lead to the positive (+) terminal of
the flat battery (1).
2. Connect the other end to the positive
(+) terminal of the booster battery
(2).
3. Connect one end of the second jump
lead to the negative (–) terminal of
the booster battery (2).
4. Make the final connection to an
unpainted, heavy metal part (i.e.
engine hook (3)) of the engine of the
vehicle with the flat battery (1).
WARNING
Never connect the jump lead directly
(1)
to the negative (–) terminal of the dis-
charged battery, or an explosion may
occur.
4) If the booster battery you are using is
fitted to another vehicle, start the
2
engine of the vehicle with the booster
battery. Run the engine at moderate
(2)
speed.
5) Start the engine of the vehicle with the
flat battery.
68LM813
6) Remove the jump leads in the exact
reverse order in which you connected
them.
81A2G-01E