Setting Up And Using The Da-5L - Samson DA-5L Manual

Setting Up and Using the DA-5L

The basic procedure for setting up and using your DA-5L UHF Antenna
Distribution Amplifier takes only a few minutes:
1. Remove all packing materials (save them in case of need for future
service) and mount the DA-5L into your rack. Turn off the power to your
audio system and all wireless components.
3. Using the supplied BNC connectors, make a connection between the
rear-panel Antenna Output 1 (Distributor A) and the "Antenna A" input
of the first UHF receiver in your system. Then make a connection
between the rear-panel Antenna Output 1 (Distributor B) and the
"Antenna B" input of the first UHF receiver in your system. Repeat this
procedure as necessary to connect the other DA-5L Antenna Outputs to
the "Antenna A" and "Antenna B" inputs of up to three additional
receivers.
4
DISTRIBUTOR A
* Third-party antennas should not be substituted.
2. Mount a tuned coaxial antenna from
your UHF receiver* into the DA-5L front-
panel "Antenna-A" input by inserting it into
the BNC connector (this connector is
"keyed" so that you may have to rotate the
antenna slightly until it drops all the way
down into the seating). Then twist the
outer ring of the antenna clockwise until it
clicks into place. Repeat the same proce-
dure in order to mount the other antenna
into the front-panel "Antenna-B" input.
Note that both antenna inputs are phantom
powered; take care not to short them.
ANTENNA OUTPUT 50
3 2 1
31