Table of Contents
Advertisement
Guided Tour - DA-5L Rear Panel
ANTENNA OUTPUT 50
1
2
1: AC input - Connect the supplied standard 3-pin "EEC" plug here.
The DA-5L contains an automatic current and voltage sensing circuitry
and so can accept any mains current from 100 - 250 volts without the
need to set a selector switch. The AC outlet used for powering the
DA-5L must be grounded. See the "DA-5L Grounding Techniques"
section on page 33 of this manual for more information.
2: Antenna Output (Distributor A) - Use the supplied BNC connectors
to connect each of these antenna outputs to the "Antenna A" inputs of
your receivers. For more information, see the section in this manual
entitled "Setting Up and Using the DA-5L" (on page 31).
3: Antenna Output (Distributor B) - Use the supplied BNC connectors
to connect each of these antenna outputs to the "Antenna B" inputs of
your receivers. For more information, see the section in this manual
entitled "Setting Up and Using the DA-5L" (on page 31).
3
SAMSON
UHF ANTENNA DISTRIBUTION AMPLIFIER
3
4
SAMSON TECHNOLOGIES CORP.
DISTRIBUTOR B
HICKSVILLE, NEW YORK, U.S.A.
1
MODEL No.DA-5H
Frequency range:947MHz to 952MHz
POWER RATING
120V~ 50/60Hz 3W
AC INPUT
(120V TO 240V VOLTAGE SENSING)
MADE IN JAPAN
30
2
ANTENNA OUTPUT 50
4
3
2
1
DISTRIBUTOR A
Hide quick links:
Advertisement
Table of Contents
