Table of Contents
Advertisement
Available languages
Available languages
12
X32 COMPACT DIGITAL MIXER
X32 COMPACT DIGITAL MIXER Getting started
(EN) Getting started
01
Ch01
A: S16
01:
0:00
- 0:00
B:
-
home
analog out
aux out
p16 out
card out
aes50-a
Channel Processing Block Patch
Inputs 1-8
Inputs 9-16
Inputs 17-24
Inputs 25-32
Aux In 1-4
Local In 1-8
Local In 1-8
Local In 1-8
Local In 1-8
Aux 1-4
Local In 9-16
Local In 9-16
Local In 9-16
Local In 9-16
Local 1-4
[Local In 17-24]
[Local In 17-24]
[Local In 17-24]
[Local In 17-24]
AES50 A1-4
[Local In 25-32]
[Local In 25-32]
[Local In 25-32]
[Local In 25-32]
AES50 B1-4
AES50 A1-8
AES50 A1-8
AES50 A1-8
AES50 A1-8
Card 1-4
AES50 A9-16
AES50 A9-16
AES50 A9-16
AES50 A9-16
AES50 A17-24
AES50 A17-24
AES50 A17-24
AES50 A17-24
AES50 A25-32
AES50 A25-32
AES50 A25-32
AES50 A25-32
AES50 A33-40
AES50 A33-40
AES50 A33-40
AES50 A33-40
AES50 A41-48
AES50 A41-48
AES50 A41-48
AES50 A41-48
AES50 B1-8
AES50 B1-8
AES50 B1-8
AES50 B1-8
AES50 B9-16
AES50 B9-16
AES50 B9-16
AES50 B9-16
AES50 B17-24
AES50 B17-24
AES50 B17-24
AES50 B17-24
AES50 A25-32
AES50 A25-32
AES50 A25-32
AES50 A25-32
Routing I/O
Input Signals can be attached to the console's internal
audio processing engine in blocks of 8 signals from any
The X32 COMPACT console features 16 analog rear-panel
one of the aforementioned input sources.
XLR inputs with microphone preamps, as well as
8 rear-panel XLR Outputs and 6 TRS Aux Sends and
Note: All signal blocks patched to the audio
Returns. In addition, there are two AES50 ports,
processing will be connected to the corresponding
each featuring 48 input and output channels, and a card
input channels automatically.
slot for 32 channels of input and output to and from a
connected computer via USB 2.0.
01
Ch01
A: S16
01:
0:00
- 0:00
B:
-
analog out
home
aux out
p16 out
card out
aes50-a
Edit Output Assignment
Analog Output
Current Setting
Category
Processed Output
Signal Tap
Output 01
MixBus
OFF
OFF
Pre EQ
Output 02
Main (LRC)
Main L
Post EQ
Output 03
Mix Bus
Main R
Pre Fader
Output 04
Matrix
Main C/M
Post Fader
Output 05
Direct Out
Main Bus 01
Output 06
Monitor
Main Bus 02
Output 07
Main Bus 03
Output 08
Main Bus 04
*Output 09
Main Bus 05
*Output 10
Main Bus 06
*Output 11
Main Bus 07
*Output 12
Main Bus 08
*Output 13
Main Bus 09
*Output 14
Select
Select
Select
Assign
Local inputs 17-24 and 25-32 are listed with brackets,
A: 48K
13:45
indicating that these are not physically available on
: 19
C: X-USB
this device. Assigning these will obviously carry no
aes50-b
signal, but they can still be used when preparing
Connected Devices
shows for a full X32 console.
AES50 A
Cabling for all AES50 connections between X32 and
S16 stageboxes:
• Shielded CAT-5e cable
AES50 B
• Ethercon terminated cable ends
• Maximum cable length 100 meters (330 feet)
Output Signals can be freely assigned from
14:09
A: 48K
any internal signal to any of the following outputs:
: 37
C: X-USB
aes50-b
• 8 analog local XLR outputs (with adjustable
digital delay for time-alignment of speakers)
• 8 virtual outputs (marked with *) for routing over
0.3
ft
0.10
m
AES50 or card outputs
0.3
ms
• 6 auxiliary sends on ¼" TRS outputs + 2x
AES/EBU outputs
Delay
• 16 channels personal monitoring using the
console's P-16 Bus output connector
Delay
Any and all of the above signals can also be mirrored
in blocks of 8 signals on either one of
Select
Delay
0.3
ms
• 48x channels on AES50 port A
Set
Delay
• 48x channels on AES50 port B
• 32x channels on USB interface card
Ch01
01
A: S16
01:
0:00
- 0:00
B:
-
con g
home
gate
dyn
eq
Insert Position
clip
t
In
-6
48V
-12
Reverse
-18
Delay
Pre
-24
ft
0.3
-30
Source
Link
Lo Cut
0.10
m
-36
OFF
-42
+0.0
dB
2.0
Hz
Input 01
0.03
ms
-48
Input 02
Input 03
-54
Input 04
Gain
Lo Cut
Delay
Input 05
Input 06
Gain
Lo Cut
Source
Delay
+0.00
dB
20
Hz
Input
0.3
ms
Link
Lo Cut
Select
Delay
LeOnde.mp3
13:44:43
00.05.00
00.00.00
29 November 2010
con g
home
gate
dyn
eq
Bus Con guration
Bus Insert Position
clip
∑
-6
Channel Sends
-12
-18
Link
Pre
-24
-30
All Channel Sends
-36
Pre Con guration
-42
...
-48
Inputs
-54
Pre EQ
Pre Fader
Post Fader
Sub Grou
Gain
Send Pos.
00.00
dB
Inputs
Link
Bus Sends
The configuration of Mix Bus Channels 1-16 can
Main Bus Channels LR/C are always available and
be pre-set (in the Setup/Global page) or can also
independent from Mix Buses. The processing steps
be configured on an individual, per-channel basis.
for this signal path include (in this order):
The bus processing includes (in this order):
• Insert point (swappable between post-EQ and
• Insert point (swappable between post-EQ and
pre-EQ operation)
pre-EQ operation)
• 6-band fully parametric EQ
• 6-band fully parametric EQ
• Compressor/expander (swappable between
• Compressor/expander (swappable between
post-EQ and pre-EQ operation)
post-EQ and pre-EQ operation)
• Bus sends to 6 matrices
• Bus sends to 6 matrices
• Main LR panning
• Mono/Center level
Quick Start Guide
Input Channels 1-16 are pre-configured to use
14:11
the local input signals 1-16, but can be patched to
A: 48K
: 37
C: X-USB
use any other available signal on the audio engine
sends
main
as well, including mix bus/sub group outputs.
Changes of the Channel Source can be made on the
Preamp Config page.
Input Channels 17-32 are pre-configured to AES50
Ins
Post
A inputs 1-16, so that connecting an S16 stage box to
Insert
port A will automatically feed the channels.
OFF
InsFX 1L
Aux Return Channels 1-8 are pre-configured
InsFX 1R
InsFX 2L
to use the 6 aux input signals, and the two USB
InsFX 2R
InsFX 3L
playback outputs, but can be patched to use any
InsFX 3L
other available signal of the console as well.
Ins Pos
Insert
FX Return Channels 1L-4R control the 4 stereo
PRE
InsF
output signals of side-chain FX 1-4.
Insert
Connect
Matrix Channels 1-6 are fed exclusively by
MAIN LRC and Mix Bus 1-16 signals. The processing
MyProj.prj
Scene01
steps include (in this order):
sends
main
• Insert point (swappable between post-EQ and
pre-EQ operation)
• 6-band fully parametric EQ
Insert
Post
• Compressor/expander (swappable between
Insert
post-EQ and pre-EQ operation)
Ins 01
Ins 02
Ins 03
Effects Processing 1-8
Ins 04
...
FX 01
The X32 COMPACT console contains eight true-stereo
FX 02
internal effects engines.
Insert Pos.
Insert
• FX 1-4 can be configured as side chain or insert
Pre
effects, while FX 5-8 can only be used in insert
Insert
Connect
points of channels or buses
• The returns of side chain FX 1-4 can always be
controlled using the 6th bank (layer) of the input
channels - Effects Returns. Note that the return
signals of FX 1-4 have separate faders for left and
right
• The FX Home screen allows selection of the
FX 1-4 input sources and selecting the effects
type/algorithm for each of the 8 FX slots of the
virtual rack
• The subsequent tabs FX 1-FX 8 of the FX screen
allow editing all parameters of the chosen
effects processor
13
Advertisement
Table of Contents
