Table of Contents
Advertisement
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
an add-in FDC or the system has no floppy drive, select Disabled
in this field.
UART2 Duplex Mode
In an infrared port mode, this field appears. Full-duplex mode
permits simultaneous two direction transmission. Half-duplex
mode permits transmission in one direction only at a time. Select
the value required by the IR device connected to the IR port
RxD, TxD Active
Consult your IR peripheral documentation to select the correct
setting of the TxD and RxD signals.
IR Transmission Delay
This setting lets you enable or disable the IR transmission delay.
EPP Mode Select
The setting for this function are EPP1.7 or EPP1.9.
Watch Dog Timer
You can enable the system watchdog timer, a hardware timer that
generates either an NMI or a reset when the software that it
monitors does not respond as expected each time the watch dog
polls it ( select the time period in a separate field ) The choice:
Disabled, 10 sec, 20 sec, 30 sec, 40 sec, 1 min, 2 min, 4 min.
Chapter 3 Award BIOS Setup
59
Advertisement
Table of Contents
