Table of Contents
Advertisement
SBC-676
Installing DRAM (DIMMs)
System Memory
The SBC-676 contains three sockets for 168-pin dual inline memory
module (DIMM). The socket uses 3.3 V unbuffered synchronous
DRAM (SDRAM). DIMM is available in capacities of 16, 32, 64, 128
or 256 MB. The socket can be filled in the DIMM of any size,
giving your SBC-676 single board computer between 16 and 512
MB of memory.
Supplementary information about DIMM
SBC-676 can accept PC-133 SDRAM DIMM Module(with or
without parity).
Single-sided modules are typically 16 or 64 MB; double-sided
modules are usually 32, 128 or 256 MB.
Memory Installation Procedures
To install DIMM, first make sure the two handles of the DIMM
socket are in the "open" position. i.e. The handles remain outward.
Slowly slide the DIMM module along the plastic guides on both
ends of the socket. Then press the DIMM module right down into
the socket, until you hear a click. This is when the two handles
have automatically locked the memory module into the correct
position of the DIMM socket. (See Figure below) To remove the
memory module, just push both handles outward, and the memory
module will be ejected by the mechanism in the socket.
10 SBC-676 User Manual
Advertisement
Table of Contents
