Panasonic WX-CC411 Operating Instructions Manual page 28

■ Wiring to the center modules
1 Remove the terminal cover.
Slide the front cover downwards by pressing its arrow-marked part and pull the lower side of the
cover toward you.
2 Insert a "minus" screwdriver in the slot as illustrated and remove the terminal socket from the main
unit.
3 Connect the wiring material to the terminal socket.
Use the "minus" screwdriver and loosen the screw located on the upper surface of the terminal
socket.
Peel off the sheath from the tip of the wiring material and insert the cable tip in the terminal socket.
Firmly tighten the loosened screw by means of the "minus" screwdriver.
Repeat the above-mentioned same procedure for each terminal.
Notes:

Process the wires according to the following:
Recommended wire type: AWG 28 - 16 (Do not use soldered wires.)
Length to be stripped: 7 mm ± 1 mm {9/32" ± 1/16"} Diameter of screw: ø 2 mm {3/32"}

Check to be sure that the wires are securely connected.
7 ㎜ 1 ㎜
{9/32 inches 1/16