■ Installation procedures
Preparations (Refer to page xx.)
Installation of center modules on the wall (Refer to page xx.)
Wiring to the center modules
(Refer to page xx.)
ID registration for follower units
(Refer to page xx.)
[System Setup]
Installed System Setting (Refer to page xx.)
Adjustments to adequate sound levels
■ Preparations
This Center Module is designed to be mounted on a wall via wall bracket. Please be advised of the
following:
-
Procure 4 mounting screws according to the material of the installation area.
In this case, wood screws and nails should not be used.
Recommended screw: M4 x 25 mm
-
Required pull-out capacity of a single screw/bolt is 118 N {12 kgf} or more.
-
If a wall board is too weak to support the total weight, the area shall be sufficiently reinforced.
How to instillation
Determination of the mounting position
Open the hole for connection wires, and determine the screw mounting position of the four locations as the
figure below. (Unit: mm)