If operating a power tool in a damp location is Intended use unavoidable, use a residual current device (RCD) Your BLACK+DECKER KW1200E, KW1200EKA router has protected supply. Use of an RCD reduces the risk of been designed for routing wood and wood products. This tool electric shock.
If the supply cord is damaged, it must be replaced by do not allow persons unfamiliar with the power tool or the manufacturer or an authorised BLACK+DECKER these instructions to operate the power tool. Power ServiceCentre in order to avoid hazard.
If the supply cord is damaged, it must be replaced by the Place a nut onto each of the screws and securely tighten manufacturer or an authorised BLACK+DECKER Service the nuts. Centre in order to avoid a hazard Fitting the distance piece (Optional) (ig. E)
(Original instructions) ENGLISH Loosen the locking screw (28). Move the batten until it is in the correct position to guide Pull the plunge lock lever (4) up. the tool. Plunge the router down until the router bit touches the Securely clamp the batten to the workpiece. workpiece.
Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-based cleaner. KW1200E, KW1200EKA Router Mains plug replacement (U.K. & Ireland only) If a new mains plug needs to be itted: Black & Decker declares that these products described under "technical data"...
Page 12
(Original instructions) ENGLISH The undersigned is responsible for compilation of the technical ile and makes this declaration on behalf of Black & Decker. Ray Laverick Director of Engineering Black & Decker Europe, 210 Bath Road, Slough, Berkshire, SL1 3YD United Kingdom 28/02/2017 Guarantee Black &...
Need help?
Do you have a question about the KW1200E and is the answer not in the manual?
Questions and answers