Samson PORTABLE PA SYSTEM EXL250 Owner's Manual page 11

EXL250m REAR PANEL
- Controls the high band of the
1
HIGH FREQUENCY
Channel Equalizer, +/- 15 dB at 12KHz.
- Controls the low band of the
2
LOW FREQUENCY
Channel Equalizer, +/- 15 dB at 80Hz.
– Effect send connected to the internal
3
REVERB
effect processor.
– Controls the channel's position between left
4 PAN
and right in the stereo bus.
– Provides smooth control over
5
VOLUME CONTROL
level changes.
– Line Input connector on the mono chan-
6 LINE
nels.
- XLR connector for low impedance micro-
7 MIC
phone input. 24 volt phantom power is supplied.
Controls the left and right placement of
8 BALANCE-
the stereo signal in the main mix output
– Stereo Line Input TRS connection
9 CH 3/4 LINE IN
Tip=Left, Ring=Right, Sleeve=Ground.
- XLR connector for low impedance
10 CH 3/4 MIC IN
microphone input.
Use grease pencil or place tape
11 SCRIBE STRIP -
here to label channels.
– Switches on the EXPEDITION EXPRESS'
12 POWER
main power.
EXL250e REAR PANEL
– Connect speaker cable from
A SPEAKER INPUT
EXL250m SPEAKER OUT here
Expedition Express Rear Panel Layout
13 AC VOLTAGE SWITCH
14 AC POWER INLET
15 LIMITER LED -
16 CD INPUTS
17 SPEAKER OUT
18 MAIN VOLUME
19 DSP EFFECTS - Used to switch between the 6 pre-
7
– Selects the operating
voltage. Make sure this switch is set correctly
for the country you are in before turning on the
EXL250m.
– Connect External AC power
supply here.
Lights whenever the built-in
Limiteris active. If you see this lighting frequent-
ly, it means you're overloading the EXL250m.
Turn down one or more of the channel Volume
controls or the Main Volume control.
– Connect a CD, DAT, Cassette or
Mini Disk here.
– Connect EXL250e external
speaker here.
- Used to control the overall vol-
ume of the Left and Right main Mix outputs.
sets of the internal DSP effects processor.