Connector Cables; Mounting And Adjusting - Panasonic CX-400 Series Instructions Manual

3

CONNECTOR CABLES

Connector cables for the M12 pigtailed type
Type
2-core type
4-core type
Connector cables for the M8 connector type
Type
CN-24A-C2
Straight type
CN-24A-C5
CN-24AL-C2
Elbow type
CN-24AL-C5

Two sets of cables are required for the thru-beam type sensor.
4 I/O CIRCUIT DIAGRAMS
The following symbols are used in this section.
Symbol Meaning
D Reverse supply polarity protection diode
Z Surge absorption zener diode
D
Tr NPN / PNP output transistor
Pin assignment
M12 pigtailed type Terminal name
1) +V
1
2
2) Not connected
3) 0V
4) Output (see note)
4
3

Only the thru-beam receiver incorporates the output.
NPN output type
Color code of cable with connector
D
(Brown / 1) +V
(Black / 4)
Output (note)
Z
T D
r
Z
D
(Blue / 3) 0V
Internal circuit Users' circuit

Only the thru-beam receiver incorporates the output.
Ramco National
Model no. Cable length
CN-22-C2 2m
CN-22-C5 5m
CN-24-C2 2m
CN-24-C5 5m
Model no. Cable length
2m
5m
2m
5m
M8 connector type
2
1
Load
12 to 24V DC
+
100mA max. ±10%
-
PNP output type
T
r
D
Internal circuit

Only the thru-beam receiver incorporates the output.
5

MOUNTING AND ADJUSTING

Mount the sensor with a tightening torque of 0.5N·m or less.
Thru-beam type sensor
1. Set the operation mode switch to the Light-ON mode position (L side).
2. Placing the emitter and the receiver face to face along a straight line.
Move the emitter up, down, left and right to determine where light is
received with the help of the receiver's operation indicator (orange). Set
the emitter in the middle of this area.
3. Adjust the angle of the emitter by twisting it up, down, left and right.
4. In a similar manner, adjust the angle of the receiver.
5. Check that the stability indicator (green) lights up.
6. Choose the desired operation mode, Light-ON or Dark-ON, with the
operation mode switch.
Object to be sensed
4
3
Receiver
2
www.PanasonicSensors.com
Color code of cable with connector
(Brown / 1) +V
Z
D
Z
D
100mA max.
(Black / 4)
Output (note) Load
(Blue / 3) 0V
Users' circuit
12mm M3 screws
with washers
Sensor mounting
bracket (optional)
+
12 to 24V DC
-
±10%
Emitter
1-800-280-6933