Download  Print this page

Connecting The Cables To The Pan/Tilt Head - Panasonic AW-PH500 Operating Instructions Manual

Indoor pan/tilt head
Hide thumbs

Advertisement

Connections

∫Connecting the cables to the pan/tilt head

¥ Pan-tilt control connector
The pan/tilt head control cable is connected here.
4
3
2
1
9
8
7
6
5
15
14
13
12
11
10
20
19
18
17
16
24
23
22
21
This connector is connected to the PAN/TILT CONTROL OUT connector on the control panel (AW-RP301, AW-RP501 or
AW-RP505) or multi-port hub (AW-HB505).
For connection, use one of the optional cables listed below.
The cable can be extended to 500 meters (maximum). To extend the cable, use a commercially available 8-pin modular jack
used for extension purposes, and extend using a 10 BaseT straight cable (UTP category 5).
When using the RS-232C interface to control the pan/tilt head, remove the cable housing of the 10-meter optional cable
mentioned above, and attach a connector which fits the unit used.
Refer to the case where control is exercised using the RS-232C interface.
≥ The brown wire is connected to pin 16.
The red wire is connected to pin 17.
The orange wire is connected to pin 18.
Pin No.
Signal
1
DI UP
2
DI DOWN
3
DI LEFT
4
DI RIGHT
5
DO RUN
6
DI OPT SEL
7
DGND
8, 9
10
HOT2
11
HOT1
12
COLD1
13
COLD2
14
TALLY IN
15
DGND
16
TXD232
17
RXD232
18
DGND
19 - 24
Pan/tilt head control cable
≥Contact control signals are not connected to this cable.
Upward direction control input (contact signal)
Downward direction control input (contact signal)
Leftward direction control input (contact signal)
Rightward direction control input (contact signal)
Rotation underway signal output
Power control input
GND
NC
Not used
Data transmitted from pan/tilt head (when controller is used)
Data transmitted from pan/tilt head (when controller is used)
Data transmitted from pan/tilt head (when controller is used)
Data transmitted from pan/tilt head (when controller is used)
Tally control input
GND
Data transmitted from pan/tilt head (RS-232C)
Data transmitted from pan/tilt head (RS-232C)
GND
NC
Not used
10 meters: AW-CA24U10
20 meters: AW-CA24U20
30 meters: AW-CA24U30
8-pin modular jack
Cable housing
13
Function

Advertisement

Table of Contents
loading

  Related Manuals for Panasonic AW-PH500

This manual is also suitable for:

Aw-ph500p