Before Using For The First Time - Russell Hobbs RHFS1 Owner's Manual

Before Using for the First Time

CAUTION: Blade is sharp. Handle carefully. Do not wash in dish-
washer. Do not immerse cord, plug or appliance in water or any
other liquid. Do not remove the the lubricant on the gears.
1. Remove any packaging materials
including any blue protective film.
Install batteries, see "Battery
Installation" on previous page.
2. Adjust the Thickness Adjustment
Knob to minimum thickness set-
ting.
3. Always make sure the unit is
unplugged and the Blade has
come to a complete stop before
cleaning.
4. Remove the Food Press, Feeder,
(see Figure 1 for disassembly and
assembly) and Food Tray and wash
in warm, soapy water. Rinse and dry
thoroughly.
5. Remove the Blade by inserting a
coin in the slot of the Blade-locking
Knob and turning clockwise.
Remove the Blade-locking Knob.
See Figure 2. With one hand on the
back side of the Blade, gently push
the Blade forward and at the same
time, grip the hole in the center of
the Blade from the front and lift off.
The Blade is very sharp, use
extreme care when handling. DO
NOT touch sharp edge of Blade.
6. Wipe all surfaces with a damp cloth.
Dry thoroughly. Keep the Control
Panel and electronic scale dry.
7. Wash the Blade, in warm, soapy water. Rinse and dry thoroughly.
Do not allow the Blade to soak in water. Trying to locate the Blade
under water is potentially dangerous.
8. We suggest that you wash, rinse, dry and reinstall the Blade imme-
diately. Re-assemble the Blade in reverse order of Step 5. Make
sure the Blade-locking Knob is properly engaged and tightened.
9. Do not remove the White lubricant on the gears. The lubricant is
used to reduce the friction and noise of the gears.
To remove Feeder, slide away from
Blade and pull up from here.
To replace Feeder, put in front track
first and press back into place.
7
Figure 1
Figure 2