Advertisement
Auto Iris function
When use the Auto Iris Lens, the control switch should be in position AI to disable AES function. Before plug the enclosed
miniature 4 pins to IRIS connector, please check the type of Auto Iris Lens, and also the compatibility on the polarities.
If the Auto Iris Lens is DC DRIVE, the control switch should be in position DC DRIVE. Adjust the LEVEL with the
VR to proper.
If the Auto Iris Lens is VIDEO DRIVE, the control switch should be in VIDEO DRIVE position.
When using the Manual Iris Lens the switch is depend on application environment. Set control switch to BLC to enable BLC
function.
.
Specification
Image pick-up device
Effective Picture Elements
Horizontal Resolution
Minimum Illumination
Auto Electronic Shutter
Signal To Noise Ratio
Auto Iris Control
Gamma Characteristic
Lens Mount
Gain Control
White Balance
Back Light Compensation
Synchronous System
Video Output
Power Request
Power Consumption
Operating Temp.
DC"
VIDEO
Drive-
Volt +
Pin1
Pin2
Drive+
N.C
Pin3
Damp+
IRIS
Pin4
Damp-
GND
SONY 1/3" CCD Normal Resolution
NTSC: 510*492, PAL: 500*582 (H*V)
420 TVL
0.05 LUX @ F1.2
ON : NTSC:1/60s~1/100,000s, PAL:1/50s~1/110,000s
OFF :NTSC:1/60s, PAL:1/50s
More than 50dB (AGC Off)
Video-Drive Lens & DC-Drive Lens both supported
0.45
C or CS mount adjustable
Automatically
Automatically (2500K~9500K)
ON/OFF Switch-able
Negative sync. Internal
1 Vp-p Composite Video / 75 Ohms. BNC connector.
DC12V/ 400mA , 50/60 Hz
3.5W
-10℃ to 50℃ (14℉ to 122℉)
Part no.:2011-L00110-002
Advertisement
