Table of Contents
Advertisement
Help with the appliance
en
3
Help with the appliance
H e l p w i t h t h e a p p l i a n c e
Faults
The appliance will not start.
Water is leaking out.
No power. The door cannot be
automatically opened.
The appliance is paused but the
drum is turning.
The programme will not start
Programme duration displayed
changes as drying progresses.
Creasing.
66
Cause/remedy
Check the mains plug and the fuses.
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
■
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
~ Page 56
If the optional drain hose* is installed, make sure that the drain hose
■
is correctly connected. ~ Page 49
Manually open the door ~ Page 33
The appliance has detected a high temperature and has started the
CoolDown process. Temperature regulation can take up to 10 minutes.
You can cancel the CoolDown process at any time by opening the door.
Make sure that:
The door is closed.
■
w has been deactivated
■
You have pressed ‹ (Start/Pause)
■
Note:
If the programme has been delayed by setting B (Ready in), the
programme will start later.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Load exceeded or incorrect programme selected for a type of fabric.
■
All the required information can be found in the programme
table.~ Page 26
Remove laundry from the drum as soon as the drying programme
■
has finished. Creasing occurs when clothing is left in the drum.
Advertisement
Table of Contents
