Table of Contents
Advertisement
Cleaning and maintenance
en
Cleaning the base unit
When drying laundry, fluff and hair from
the laundry is collected in the fluff
collector. Your appliance's display
reports that the fluff collector is full.
Clean the appliance's base unit if the
following message appears in the
display: Lint filter full. Length of drying
cycle affected. Remove and empty the
lint filter and the lint trap. Then clean
both with warm water..
You can also clean the appliance's
base unit if this message does not
appear in the display. e.g. before each
time maintenance work is carried out on
the appliance or the appliance is
switched off for longer than a month.
Notes
If the message Lint filter full.
■
Length of drying cycle affected.
Remove and empty the lint filter
and the lint trap. Then clean both
with warm water. appears in the
display, confirm the message in the
display.
Allow the appliance to cool down for
■
approximately 30 minutes after use
before commencing cleaning.
Clean the base unit as follows:
To open the maintenance flap, take
1.
hold of it at the top at both sides and
pull it down.
56
Clean the maintenance flap with a
2.
soft, damp cloth.
Unlock the levers on the heat
3.
exchanger cover.
Pull the heat exchanger cover out by
4.
its grip.
Advertisement
Table of Contents
