Cook Time; Delay Time; Start/Stop - Russell Hobbs RHNPC800P Nutritionist Owner's Manual

Programmable pressure cooker
Table of Contents

Advertisement

Control Panel Options
Once pressure is reached, the unit will begin to count down in minutes
and will beep 3 times when the cooking time has elapsed. The
Pressure Cooker will beep periodically as a reminder that your cooking
is completed. To cancel this, press and hold the START/STOP Button
until it beeps. Let the pressure drop on its own by using the Natural
Release Feature, or release pressure immediately by pressing the
QUICK STEAM RELEASE Button in short bursts until pressure is
reduced.
WARNING: DO NOT hold the QUICK STEAM RELEASE Button
down, as hot liquids may be ejected. Press in short bursts until
pressure is reduced.
NOTE: To cancel or stop cooking before time has elapsed, press and
hold the START/STOP Button until the Red STOP Light illuminates
and the Pressure Cooker beeps.
4. COOK TIME: Use this Timer when using the COOK MODE (STEAM)
or the PRESSURE MODE (HIGH or LOW) settings. Press COOK TIME
Button to set the desired cooking time.
5. DELAY TIME: Allows you to begin cooking food up to two hours later
in 1/2 hour increments.
6. START/STOP: After choosing the desired modes: WARM, COOK
MODE: (BROWN or STEAM), or PRESSURE MODE: (HIGH or LOW),
and if appropriate, the COOK TIME, press the START/STOP Button to
begin operating the appliance. The Green Indicator Light will be lit
when START is chosen. The Red Indicator Light will illuminate for
STOP. If you wish to change your selection, or to stop the appliance,
press and hold START/STOP until the Red STOP Indicator Light illumi-
nates and the Pressure Cooker beeps.
This Pressure Cooker has an idle mode. If you input a COOK TIME and/or
DELAY TIME, but forget to select a program or if you forget to press
START, the clock will display "--" after 5 seconds. This feature is for your
convenience to show that the program is incomplete. The "--" signal indi-
cates that the Pressure Cooker is not programmed properly and will not
run. You can proceed with the program where you left off by pressing the
COOK TIME or DELAY TIME Button. Your selected time will reappear. If
this time does not appear, or if it is incorrect, simply enter the correct time
and then press the START/STOP Button.
8
(Cont.)

Advertisement

Table of Contents
loading

Table of Contents