Error Messages On The Cycle Computer - Shimano Steps BT-E6000 User Manual

„ Error messages on the cycle computer
Warnings
This disappears if the error is fixed.
Display
Code
preconditions
The temperature of
W010
the drive unit is high.
The traveling speed
W011
cannot be detected.
Two or more assist
switches are
W030
connected to the
system.
An electronic
derailleur may have
been installed in
W032
place of a
mechanical
derailleur.
A communication
error between the
- drive unit and the
motor unit was
detected.
Operational restrictions
while warning is
displayed
The level of assistance
may decrease.
The maximum speed up to
which power assistance is
provided may decrease.
(Power assistance is provided
up to 25 km/h in top gear.)
Gear shifting is not
available for electronic
derailleurs.
Power assistance
provided in [WALK]
mode may be lower
than usual.
* The walk assist mode
function may not
available in certain
regions.
Gear shifting is not
available for electronic
derailleurs.
52
Remedy
Stop using the assist function until the temperature of
the drive unit drops.
If the situation does not improve, contact the place of
purchase.
Check that the speed sensor is properly installed.
If the situation does not improve, contact the place of
purchase.
Change the assist switch to the gear shifting switch, or
connect only one assist switch and turn on the power
again.
If the situation does not improve, contact the place of
purchase.
Reinstall the derailleur for which the system is
configured to support.
If the situation does not improve, contact the place of
purchase.
Check that the cable is properly connected between the
drive unit and the motor unit.
If the situation does not improve, contact the place of
purchase.