Installation; Placement; Mounting Instructions - Honeywell E529 Product Manual

E529 Product Guide

Installation

Placement

Mounting Instructions

Rev 2.0 3/20/2017
CAUTION!
• The E529.4G is intended for indoor use only.
The E529.4G installer must be a trained, experienced service
•
technician.
All wiring must comply with local codes and ordinances.
•
Failure to follow the instructions provided with the product could
•
damage the product or cause a hazardous condition.
Since the E529.4G has the sensor to measure room temperature, it should
be installed in a location that represents the desired room temperature. In
addition, select a location that minimizes exposure to conditions that interfere
with room temperature measurement, such as away from external doors or
windows and areas in direct sunlight.
RF is critical to the E529.4G's operation, so placement of the device and
careful consideration of possible sources of radio interference are important.
For instance, the unit should not be placed close to floor or ceiling or near pipe
or other metallic items.
1. Separate the E529.4G body and the mounting plate by pulling the bottom
of the mounting plate away from the E529.4G body and then pull the
mounting plate down. NOTE: If the back-mounting plate is rotated more
than 2 or 3 degrees, the plastic tabs at the top of the plate may fracture
or break off.
2. Attach the mounting plate to the wall or electrical box with the arrow
embossed on the mounting plate pointing upward. The E529.4G is
provided with four 6-32 ¾" sheet metal screws for mounting the plate to
an existing 4" × 4" electrical box. If attaching the mounting plate to
sheetrock or a similar wall surface, install four 6-8 × ¾ anchors. The four
holes on the mounting plate can be used to mark the location for the
anchors.
3. Install the four AA alkaline batteries (NOTE: Use alkaline batteries only)
provided into the battery compartment located on the rear of the
E529.4G. Depress the battery clamp latch at the top of the battery
compartment and then swing open the battery clamp. Insert the 4 AA
alkaline batteries, matching the "+" terminals on the batteries to the "+"
symbols in the battery compartment. Close the battery clamp and verify
the latch is securely fastened.
4. Verify that the E529.4G display is now showing information. At power ON
(ie inserting the 4 AA batteries), confirm all segments and characters are
displayed on the E529 LCD display. If the display is blank, verify that the
7