Actavo BoSS SOLO 700 User Manual page 9

www.actavo.com
BoSS SOLO
700
Assembly Procedure
6
From the ground level, position a trapdoor deck on rung 8.
Engage the windlocks. Locate Assembly Bracket No 1. on front
face of lowest Cam-Lock Guardrail. Locate the second
Assembly Bracket on rung 10 of the end frames.
7
Hang in order, 4 Cam-Lock Guardrail units on the front
Assembly Bracket and then 1 x Folding Toeboard. Place the last
Cam-Lock Guardrail on the end frame Assembly Bracket No 2.
Then hang two pairs of connected 4 rung frames on the end
bracket No 2. then hang the second trapdoor deck on the bracket.
Warning: Assembly Brackets are designed and intended only to
aid assembly and dismantling.
FREEPHONE: 0800 214 005
USER GUIDE
Assembly Procedure
8
Climb the tower from the inside and from a protected
position on the trapdoor, reach to the side bracket and take one
Cam-Lock Guardrail. Position the guardrail on the rear of the
tower as shown. All guardrails locate on the 2nd and 4th rung
above the platform deck. Repeat with second Cam-Lock
guardrail frame on the front of tower to fully secure platform.
Engage and lock Cam-Lock claws.
Do not climb onto the platform until it is fully guardrailed.
Standing up on the protected platform, left
9
the second trapdoor deck onto the
platform, store by the rear handrail clear of
the end frames.