Table of Contents
Advertisement
www.actavo.com
BoSS SOLO
700
Assembly Procedure
To comply with the 'Work at Height Regulations' we
show assembly procedures with platforms every 2
metres in height and the locating of guardrails in
advance of climbing onto a platform to increase safety
and reduce the risk of a fall.
Never stand on an unguarded platform positioned above
the first rung of a tower. If your risk assessment shows
it necessary, you may also need to guardrail platforms
at this level.
The procedure illustrated shows 6.2m working height tower.
The BoSS Solo system has been developed so that a single
person can safely build the platform tower to a platform height of
4.2m.
1
Insert castor into adjustable leg, apply brake by pushing the
lever down, release frame interlock clips and fit the leg and castor
assembly into a 1m base frame. Repeat with the remaining legs
and castors. Adjustable legs should only be used for levelling.
FREEPHONE: 0800 214 005
USER GUIDE
Assembly Procedure
2
Release brakes on castors at one end frame until the
locks will engage on the rear folding frame. Ensure both
hinges positively lock into position. Engage brakes on
second frame.
3
Locate the horizontal brace on the lowest rung with the
hooks facing downwards - check the brace is correctly locked on
the tube at both ends. Check the base unit is square and level
using a spirit level. Adjust legs only to level and not to gain
additional height.
Advertisement
Table of Contents
