JTS CX-500F User Manual

CX-500F MA-500
/
Condenser Instrument Microphone / Phantom power Adapter
The CX-500F is built with full range omni directional capsule with golden plating in and
outside. The at frequency response reproduces all types of utes. Dynamic design of mic
holder can rmly mount CX-500F to utes with di erent sizes while the dual injection
design prevent the ute from scratch. The exible mini gooseneck renders a desirable
miking position while minimizes air stream noises and blasts.
Omni directional pick up pattern
Flat frequency response
Versatile mount clip
Terminated with 4 pin mini XLR for easy wireless application
Phantom power adapter with low cut and pad provided for wired application
Parts ldenti cation
1 CX-500F Miniature microphone: 1 piece
2 MA-500 Adapter: 1 piece
3 Windscreen (reticular foam cover): 4 pieces
CX-500F / MA-500
Condenser Instrument Microphone / Phantom power Adapter
Speci cation
CX-500F
Type.............................
Omni-directional Condenser
Frequency Response.... 20~20,000 Hz
Sensitivity (at 1,000Hz) -58±3dB*(1.25mV)*0dB=1V/ bar
Impedance.................. 1.5k
Max.SPL for 1% T.H.D. 130 dB
Signal-To-Noise Ratio
68 dB
Output Connector....... 4P Mini XLR
Power Supply............. 1-5 VDC
Current Consumption ≤0.05mA
Weight...................... 8 grams (including cable)
Dimensions(mm)...... Ø6mm(W)*171mm(H)
+10
0
-10
20 100 200 500 1k 2k 5k 10k 20kHz
MA-500
MIC Input.................. 4P Mini XLR(Male)
Output...................... XLR(Male)
Phantom Power........ 12~48V
PAD........................... -10dB
Low Cut..................... 100Hz -6dB
400Hz -4dB
Frequency Response 30~20,000Hz
Impedance................ 220Ω
T.H.D......................... <0.045%@1KHz -50dB
S/N............................ >95 dB
Weight...................... 40g
Dimensions(mm)...... Ø20mm*94.5mm(H)
M C I N I
Input: 4P Mini XLR (Male)
1 3
4
Pin 1: GND
Pin 2: V+
2
Pin 3,4: Audio signal
O U T P
Output: XLR (Male)
Pin 1: GND
1
3
Pin 2,3: Audio signal
(Phantom Power Supply)
CX-500F / MA-500
Condenser Instrument Microphone / Phantom power Adapter
User Manual
Open the rotational button on the xing clip.
1
Place the xing clip into the ute and fasten the rotational button.
2
3 Place the CX-500F into the xing clip.
Adjust the position of CX-500F gooseneck microphone, and it is then ready.
4
1
2
}
125Hz 2000Hz }
250Hz 4000Hz
}
500Hz 8000Hz
1000Hz 16000Hz
3
4
MIC IN
V+
U T
2
PIN2 OUT(+)
PIN3 OUT(−)
Please maintain the temperature in proper status it helps the Submin-
iature Condenser Instrument Microphone to lengthen its life.
Using the part and adapter made from JTS to ensure the unit quality
and lifetime. Do not attempt to employ non-standard adapters or
connectors as you might damage the unit
59010-091-01